Play and Charge Kit: Difference between revisions
Jump to navigation
Jump to search
imported>Stoker25 No edit summary |
imported>Stoker25 No edit summary |
||
| Line 1: | Line 1: | ||
{{Cleanup}} | |||
The '''Play and Charge Kit''' is sold separately from the Xbox 360 Wireless Controller. It contains a rechargable battery pack and a USB cable which connects the controller to the console. | The '''Play and Charge Kit''' is sold separately from the Xbox 360 Wireless Controller. It contains a rechargable battery pack and a USB cable which connects the controller to the console. | ||
| Line 10: | Line 11: | ||
[[Category:Hardware]] | [[Category:Hardware]] | ||
Revision as of 02:50, 1 August 2010
 |
This page needs to be cleaned up, because its either hard to read or contains very little information. You can help Free60 by editing this page and cleaning it up. |
The Play and Charge Kit is sold separately from the Xbox 360 Wireless Controller. It contains a rechargable battery pack and a USB cable which connects the controller to the console.
Battery Pack
The battery pack that comes with the Play amd Charge Kit contains 2 standard rechargable AA batteries soldered to a control circuit board with a 6-pin header.
The pinout for the header is (left to right): Temp, P-/GND, SCK, SCA, P, VCC
The SCK, SCA, GND, and VCC pins are connected to an AT24C04M 2-wire serial EEPROM chip. Presumably the controller checks the EEPROM to verify that the battery pack has been charged fewer than a factory-set number of times and stops charging if that number is exceeded.